how to fix car engine off by seeing ignition

 various ways you have done to repair your car vehicle that often strike or die total.behavior when you drive a car smooth and rough, also affect the life of your car engine, if you drive a car or motor vehicle in a smooth way then the period to your vehicle engine will be longer and durable.
 if you have already experienced your machine often experience a strike and total death, here I will give a simple way to find out in which part you should check your vehicle engine.how to fix car engine off by seeing ignition
 step you should know and you do to know where your vehicle engine is damaged ie there are three steps


1.selective octane ignition checks on car           engines


 first check the selective octane position and its placement should be right at the standard position,first check the selective octane position and its placement should be right at the standard position

2.disconnect the vacuum hose leading               distributor and then close or sumbatlah       the vacuum hose.

3.turn on your car engine and let it run idle

4.and attach the timing light correctly in           Figure A.
   one cable attached with one spark plug         wire
   (and as the founder of the voltage cable)
    As in the picture Here, one cable in                connect with spark plug wire 2, as the            founder you signal voltage.
   2 and 3 cables to the voltage source, ie           cable 2 to the positive battery and cable 3     to the voltage or negative source of the         battery or it could be to the body of the
   machine

5.and the fifth section Direct the timing             light towards the crankshaft pulley                 correctly


6.also Check the ignition time (for your             vehicle 5k series when ignition is 5o ± 2         before TMA).


7.do not forget to reconnect the vacuum           hose to the diaphragm vacuum at the             distributor.


8.and the last turn off your vehicle engine



Setting procedure during ignition when machine is on


1.Do a check on ignition as above steps (A)       and (B)

2.If when ignition is not right then setelsaat     ignition by way of kendanger first bolt           distributor binder, after that turn the             distributor while directing the timing light
   toward the crankshaft pulleys

3.After the ignition is correct, then tighten       the bolt back of the distributor


5.and lastly Replace the removed                       componentsc as they were in the original     state ..