if you have already experienced your machine often experience a strike and total death, here I will give a simple way to find out in which part you should check your vehicle engine.how to fix car engine off by seeing ignition
step you should know and you do to know where your vehicle engine is damaged ie there are three steps
1.selective octane ignition checks on car engines
first check the selective octane position and its placement should be right at the standard position,first check the selective octane position and its placement should be right at the standard position
2.disconnect the vacuum hose leading distributor and then close or sumbatlah the vacuum hose.
3.turn on your car engine and let it run idle
4.and attach the timing light correctly in Figure A.
one cable attached with one spark plug wire
(and as the founder of the voltage cable)
As in the picture Here, one cable in connect with spark plug wire 2, as the founder you signal voltage.
2 and 3 cables to the voltage source, ie cable 2 to the positive battery and cable 3 to the voltage or negative source of the battery or it could be to the body of the
machine
5.and the fifth section Direct the timing light towards the crankshaft pulley correctly
6.also Check the ignition time (for your vehicle 5k series when ignition is 5o ± 2 before TMA).
7.do not forget to reconnect the vacuum hose to the diaphragm vacuum at the distributor.
8.and the last turn off your vehicle engine
Setting procedure during ignition when machine is on
1.Do a check on ignition as above steps (A) and (B)
2.If when ignition is not right then setelsaat ignition by way of kendanger first bolt distributor binder, after that turn the distributor while directing the timing light
toward the crankshaft pulleys
3.After the ignition is correct, then tighten the bolt back of the distributor
5.and lastly Replace the removed componentsc as they were in the original state ..